Titanium Replaceable Spotweld Tip

These spotwelding tips come in various sizes that correspond to various thicknesses of sheet materials. The "nose" of the tip passes through the upper sheet and into the lower sheet. The tip should be selected based on the thinner sheet dimension, and the horn tip should approach from the thinner sheet side of the assembly. The flash ring on the tip provides a spot weld that looks much like a blind rivet. Properly done, a spot weld using this technique is not visible from the non-horn-contact side of the assembly. Rapid tip wear should be expected if used on glass-filled or abrasive materials.

Consult the Dukane horn catalog for specifics on tip sizing.

Replaceable tips are not recommended for high volume production.

Now accepting on line orders from:
United States and U. S. possessions, American Samoa, Antarctica, Bahrain, Bangladesh, Belize, Bolivia, Botswana, Brazil, Canada, Chile, Colombia, Costa Rica, Djibouti, Dominican Republic, Ecuador, Egypt, El Salvador, Guam, Guatemala, Haiti, Honduras, India, Marshall Islands, Mexico, Mongolia, Nicaragua, Nigeria, Northern Mariana Islands, Oman, Panama, Uruguay, Venezuela, VietNam
(Others please contact us by e-mail, fax, or phone.)
NOTE: ALL PRICES EX-WORKS DUKANE ST. CHARLES, IL, USA (INCOTERMS 2000)

Dukane Intelligent Assembly Solutions - 2900 Dukane Drive - St. Charles, Ilinois 60174 USA
Telephone +1-630-797-4900 - Fax +1-630-797-4949
Copyright 2000-2005 Dukane Corporation. All rights reserved.
Revised 20 August 2007